Driver: L298N Dual H Bridge DC Motor Driver

Driver Terminal Power Supply: +5 V ~ +35 V; (If you need power from the board, it should be +7V~+35V.)

Peak Current of the Drive Part:2A

Current of the Logic Part:0~36mA

Control Signal Input Voltage: Low:-0.3V ≤ Vin ≤ 1.5V; High: 2.3V ≤ Vin ≤ Vss

Enable Signal Input Voltage: Low: -0.3 ≤ Vin ≤ 1.5V (control signal is inactive); High: 2.3V ≤ Vin ≤ Vss (control signal active)

Maximum Power Consumption: 20W ( at 75�)

Storage Temperature: -25� ~ +130 �

Other Extensions: Control indication light, logic unit power supply interface.

Features:

The drive module is made of brand new L298N chip of ST company, working stably by SMT techniques and firmly circuit.

It can drive directly two 3-30V DC equipments and supply 5V output, and supply power for 5V microcontroller unit.

It can support 3.3V MCU ARM control so as to change the speed and direction.

Also it is suitable for 2-phase stepper, 5-phase 4-shot stepper and widely used in intelligent cars.